Elinchrom EL Skyport, Universal Radio Receiver Slave.
from Elinchrom
- The included Charger recharges the Li-Ion battery in approximately 3 hours.
- The LED indicates charge and operating modes.
- When used with the EL-Skyport wireless software, this module is recognised as a flash unit and accepts both triggering and Flash-Delay settings - for example, where sequenced flash may be required
- All other features and performance are the same as the EL-Skyport Transmitter.
The Universal Receiver is compatible with Elinchrom and other flash brands. Delivered with one Elinchrom standard sync cable and one 3.5 mm jack. The internal, rechargeable Li-Ion battery provides about 30 hours of operation. To maximise battery life, the Auto-Standby function activates if the unit is not used for 4 hours. The Charger can be connected to the mains whilst the Universal Receiver is in operation. The status LED shows charge and operating modes.
MicroSync Digital Transmitter / Receiver Kit with Mono Plug
from MicroSync
- Please Note; This system won't work with units that operate on less than 5 volts!
- Transmitter Max range: 100 ft
- Max sync speed: 1/180 sec
- Channels: 4
- Frequency: 433 MHz
The MicroSync Digital is the smallest smartest wireless solution for firing strobes and cameras. The Freedom of Wireles: Whether your'e shooting in the studio or on location, firing your strobes with a sync cord can be impractical, inconvenient, and sometimes even impossible. Not any more! The MicroSync Digital wireless strobe sync system allows you to fire strobes wirelessly. So liberate yourself from the limitations of your sync cord. Ultra Small, Light and Convenient: The MicroSync Digital is revolutionary because it is super minature, extremely lightweight, and almost operates itself. Just place the transmitter in the hotshoe of your camera, plug the receiver into your strobe's powerpack and fire! Its that easy. Automatic Power Management: The MicroSync Digital has a unique automatic on/off power management system. There are no on/off switches on the transmitter or the receiver. When you press the shutter the transmitter turns itself on, sends the signal to the receiver, then turns itself off, all in milliseconds. Because of this advanced power management system, the battery life of the coin cell in the transmitter is anticipated to be 3 years. Four Channels: There are four channels on the MicroSync Digital to allow you to shoot without interference from other MicroSync users in close proximity.
Smith Victor RTK4 4 Channel Radio Trigger Kit
from Smith-Victor
Smith Victor introduces the lowest cost radio triggering system available for electronic flash units. This 4 channel system is designed for use with both portable off-camera flashes and studio strobes. This unique accessory gives you reliable radio technology to trigger strobes up to a distance of 150 feet without sync cords or optical slaves. Improve your digital images by eliminating sync cord line noise. Easy To Use: There is no time consuming program or setup procedure. Simply slide the radio transmitter into the cameras hot shoe. Plug the receiver into the flash unit sync outlet and you are ready to shoot. The receiver can be attached to the strobe or light stand with hook and loop strips. The Smith Victor radio triggering system is for use with electronic flash. units having 1/4" phono plug and mini sync outlets. Multi Light Triggering: Using this amazing system at weddings or public events means you can set up individual or multiple flashes and never worry about another photoprapher's triggering your lights. For a fully encrypted multi-light system, one receiver is required for each light
Pocket Wizard MultiMAX Transceiver, Remote Control Radio Slave.
from Pocket Wizard
- Wireless Transceiver Technology
- True Trigger Confirmation
- Selective Quad-Triggering
- Digital Radio Technology
- Rear Curtain Sync
The PocketWizard MultiMAX Transceiver features Wireless Transceiver Technology, which eliminates the need for a separate transmitter and receiver setup. Each MultiMAX provides the capability to send and/or receive digital signaling by a flip of a switch, similar to personal communicators. Among many advantages, a photographer can select between a transmitter or receiver mode as shooting assignments change.The MultiMAX is the only radio system that offers True Trigger Confirmation feedback, up to 1600 feet away or more, without the need for signal repeaters or daisy-chained radios. Selecting which camera or flash zone fires is as easy as pressing a button in "Selective Quad Triggering" mode. The MultiMAX automatically confirms radio triggering on every zone simultaneously, with immediate visual and audible feedback on the MultiMAX (set for transmitter).Utilizing LPA Design's patented microprocessor and software technology, the MultiMAX comes loaded with "Trigger Time Control" software. Used independently or with another PocketWizard, the MultiMAX provides several unique advanced tools for the working professional, all in one small package. With the "Trigger Time Control" software, it's easy and very convenient to create rear curtain sync effects with any camera, add depth of field using multi-pop mode, record events as they unfold using the intervalometer mode and much more.As with all PocketWizard Digital Radio Receivers, the PocketWizard MultiM
Interfit Photographic Radio Transmitter Kit (Transmitter and Receiver)
from Interfit Photographic
A simple, economical one channel radio slave kit
Smith Victor RTR 4-Channel Radio Trigger Receiver
from Smith-Victor
Use a seperate receiver on each strobe if your stobes photo cell is not visible, if it is too far away, or to "turn off" the photo cell to prevent unwanted triggering from another photographers flash.
Bowens Multi-functional Transceiver Pulsar Radio Slave Trigger Twin Pack, for Cameras, Flashes and Light Meters
from Bowens
- Radio Transmitter: Pulsar can trigger devices around corners and through walls.
- 100m Range: Pulsar allows photographers to work further distances from their light source.
- It's a Transceiver: Pulsar can be a transmitter or receiver at the touch of a switch.
- Long battery life up to 200 hours of continuous use from two AAA batteries.
- Low voltage operation of just 3V making it ideal for use with sensitive digital cameras.
The Bowens Transceiver Pulsar Radio Slave Trigger is a multifunctional device, which can be used to trigger flash units, film and digital cameras and light meters up to 100m. Because it uses radio transmission, rather than IR, it allows triggering around corners, through walls and is not affected by high ambient light situations. Choose from four individual channel and six studio selectors, each providing a unique ID for a different flash device or combine them to trigger all equipment within a given setup or studio. Pulsar also features a hot-shoe mount, sync in and sync out terminals, a ready indicator, a test button and an external power option. Because of its low-voltage operation, it is perfect for digital cameras. Each unit can be used as either a transmitter or receiver and is powered by just two AAA batteries. Whether you are triggering flash heads for complicated lighting setups or cameras for remote control nature shots or applying a special effect, this system is for you. Each Pulsar unit can be either a transmitter or receiver and is capable of sending or receiving signals beyond 100m (333'). The Pulsar has four separate channels, enabling the photographer to isolate up to four light sources or to combine them and fire all of them at once without leaving the camera. Additionally, the Pulsar has a studio selector switch, which provides isolation from other Pulsar units using the same channel, and allowing up to six different systems to
Elinchrom EL Skyport, RX Flash Trigger Set
from Elinchrom
The EL-Skyport RX Trigger Set allows you to wirelessly control your Elinchrom RX flash units from the included transmitter. The set includes one Transmitter, and two Transceiver RX s. The EL Skyport Transmitter allows you to fire your strobes wirelessly up to 164 in the studio and 394 outside. When used with Elinchrom RX heads or packs, the transmitter can wirelessly adjust the flash power in 1/10 stop increments and turn on and off the modeling lights. The transmitter has four selectable workgroups and eight frequency channels to give you further control in firing separate groups of lights and adjusting groups of lights. The Skyport Transceiver RX module fits only Elinchrom RX units using the integrated multiple interface for triggering and for the computer remote operating option. No internal battery is required, just plug into a Style RX, Ranger RX or Digital RX flash unit (Please remember to double check the Group and Channel Frequency settings) and the Transceiver RX is ready to use. To control the flash power, modeling lamp and flash synchronization, only the Transmitter (sold separately) is required. To control all RX functions, the latest EL-Skyport software and USB Transceiver RX (both sold separately) is required. NOTE! To connect the Skyport Transceiver RX module to the Charge/Remote socket of the Ranger RX battery pack, the Remote Adapter 19374 or Remote Adapter Cable 11110 is required.
Elinchrom EL Skyport, USB RX Radio Transceiver Slave.
from Elinchrom
EL Skyport USB RX Transceiver (EL 19354) The EL Skyport USB RX Transceiver works in conjunction with the free EL Skyport Software, available for PC or Mac. The USB RX Transceiver is designed to send and receive information from the Universal Receiver and the RX Receiver. The EL USB RX Transceiver: Provides communications between the computer and the lights used on a project Supports four workgroups and can control individual, groups or all heads No battery necessary as power comes from the computer EL Skyport Software The EL Skyport works with PC and Mac's and is designed to help create, fine tune, document (then save for future use) the simplest to the most complex of lighting projects. Skyport software requires a Skyport USB RX Transceiver to work, and when launched will located any flash unit that has a Skyport Universal or RX Receiver. When it locates an RX head or pack it will provide a duplicate of the units control panel. Everything that can be controlled from the head or pack can be controlled from Skyport software. The USBRX Transceiver: Can control up to 16 lights per workgroup, 64 per studio Complex lighting setups (studio, camera, object, background and light positions) can be documented, saved and printed Lighting setups can be edited and used over and over Stroboscopic effects can be created easily using any connected head Built in module tester
Quantum FW-7Q FreeXWire Radio Receiver for the Qflash 4d or 5d Flashes.
from Quantum
Receiver FW7Q - totally cordless - Team up a FW7Q Receiver with a FW9T Digital Transmitter. FW7Q mounts flush to Qflash 4d or 5d. Mount an FW9T Transmitter and FW12 Hot Shoe Adapter to the camera hot shoe to be totally wireless. Or, add a Dor Dw series QTTL adapter to the camera and transmit your camera's f/stop, ISO, and TTL exposure information to the remote Qflash 5d.
+++
